Rewiring & Code Corrections in Denver, NC

Cost tracks square footage, how many circuits are involved, how accessible the walls and attic are, and whether the panel has to be replaced too. A targeted rewire of a few problem circuits is a fraction of a whole home job. We give you a written, itemized scope after a free on site assessment so you are never working off a guess.

A partial rewire is often a few days. A whole home rewire on an occupied house typically runs one to two weeks. Most families stay in the home while we work, because we take it room by room and restore power at the end of each day wherever possible. We tell you the plan up front.

Not always replaced. Aluminum branch wiring can often be remediated at the connections with approved connectors, which is far less invasive and far less expensive than a full rewire. We inspect what you have and tell you honestly which route your house needs and what your insurer is likely to accept.

Knob and tube is the ungrounded wiring used in homes built before roughly 1950, run on ceramic knobs and tubes. It has no ground, the insulation is usually brittle by now, and most insurance carriers will not cover a home that still has active knob and tube. If yours is still live, replacement is the right call.

Yes, and it is a large part of what we do. Bring us the inspection report or the correction notice and we will price the items line by line, make the repairs to current code, and meet the inspector for the reinspection so your project or your closing keeps moving.

Almost always. Replacing circuits, adding grounds, and correcting violations are permitted work in Lincoln, Catawba, Iredell, Gaston, and Mecklenburg Counties. We pull the permit and handle the inspection, which also gives you a documented record that the work was done to code.